產(chǎn)品詳情
1. Disclaimer
Please read this operation manual carefully before using this equipment, and operate, maintain and maintain it according to the instructions of this manual. The equipment user shall be responsible for equipment damage and personnel injury accidents caused by illegal operation, maintenance and service.
2. Safety Guide
Warning! Only professional technicians are allowed to install and debug the equipment!
Warning! Even if the equipment stops running, the temperature in the heating zone may still be very high!
Warning! When the equipment is working properly, there will be high temperature on the surface of the box body. Please do not contact directly with the skin to avoid scalding.
Warning! The PE line of this equipment must be connected with the PE line in the factory.
Warning! The equipment should not be too close to the wall to keep the heat dissipation of the machine smooth.
3. Equipment Overview
3.1 Product overview
WLRS1826-Lelectric heating air heater is mainly applicable to the heating of heat-shrinkable tubes. It can adopt various control bs, and can freely adjust the heating time and stop time according to the actual needs. The heating can be started by manual triggering, or the heating can be started and stopped by automatic circulation.
This machine is suitable for heating and shrinking of heat-shrinkable tubes in wire harness processing enterprises. The operation time, working time and heating zone width can be adjusted arbitrarily according to the production process requirements. It can work continuously for 24 hours.
3.2.Equipment comb
The equipment is composed of control box, heater, online harness and timing signal trigger (foot switch)
3.3 Equipment characteristics
Multiple control bs can be selected according to needs:
Place the product properly, trigger the foot switch, and heat it up. (Setting: Remote P37)
Cycle automatic start stop heating mode. (Setting: Remote P33)
Heating b:
Using infrared radiation heating, there are 6 infrared tubes at the top and bottom, and the corresponding 2 heating tubes at the top and bottom are 1 group, totaling 6 groups. Among them, 4 groups can be individually switched on and off, and suitable infrared tubes can be selected according to different heating widths.
Heating zone insulation design:
The shell of the upper and lower heating zones adopts a double-layer design and is equipped with cooling fans, which can reduce the temperature of the shell, prevent scalding accidents, and cool the internal circuits to prevent high-temperature scalding of wires.
4.Main technical beters
|
category |
project |
beter |
|
size
|
Heating zone width |
≤260mm |
|
Length of heating zone |
≤180mm（Adjustable） |
|
|
Heating pipe |
Heating pipe name |
Infrared radiation tube |
|
Heating tube power |
300W*12 （Standard configuration） |
|
|
heating temperature |
≤260℃ |
|
|
Power Supply |
Power specification |
AC 220V |
|
Overall power |
4000W（Standard configuration） |
|
|
security |
safety protection |
PE |
5、 Installation and debugging
Equipment size
